Manuel d'utilisation / d'entretien du produit RS660BXV du fabricant Whirlpool
Aller à la page of 24
.
Contents Page BEFORE YOU USE YOUR RANGE 2 IMPORTANT SAFETY INSTRUCTIONS. 3 PARTS AND FEATURES 4 USING YOUR RANGE. 5 Using the Surface Units 5 Optional Canning Kit 6 Setting the Clock 7 Using the Minut.
IMPORTANT 1. DO NOT allow children to use or 6. KEEP pan handles turned in, but ploy with any port of the range, not over another surface unit to or leave them unattended near it. ovoid burns, injury and to help They could be burned or injured. prevent the utensil from being 2.
Parts and features Model RS660BXV AUTOMATIC MEALTIMER* STOP CLO~KIMINUTE TIMER T!ME SURFACE UNIT INDICATOR LEFT REAR START CONTROL KNOB TIME ONE-PIECE CHROME REAR SURFACE REFLECTOR BOWLS UNIT SIGNAL L.
OVEN “HEATING” Using your range Using the Surface Units Control knobs must be pushed in before turning them to Q setting. They con be set anywhere between HI and OFF. Surface Unit Indicators The solid dot in the surface unit indicator shows which surface unit is turned on by that knob.
Use only flat-bottomed utensils for best cooking results and to prevent damage to the cooktop. Specialty items with rounded or ridged bottoms [woks, ridged bottom canners or tea kettles] are not recommended. See the Cooking Guide for important utensil information.
Setting the Clock Push in and turn the Minute Timer Knob to set the Clock. 1. Push in Minute Timer Knob and turn clockwise until clock shows the right time of day. 2. let the Minute Timer Knob pop out. Turn clockwise until Minute Timer hand points to OFF.
Using the Oven Controls Baking Position the rack(s) properly before turning on the oven. To change rack position, lift rack at front and pull out. The rack(s) should be placed so the top of the food will be centered in the oven. Always leave at least 1Yz to 2 inches (4-5 cm] between the sides of the pan and the oven walls and other pans.
Adjusting the Oven Tempemture Control Does your oven seem hotter or colder than your old oven? The temperature of your old oven may have shifted gradually without you noticing the change. Your new oven is properly adjusted to provide accurate temperatures.
Broiling 1. Position the rack before turning the oven on. See “Broil Chart” in the Cooking Guide or a reliable cookbook for recommended rack positions. 3. Close the door to the Broil Stop position (open about 4 inches, 10.2 cm]. The door will stay open by itself.
Using the Automatic MEALTIMER* Clock The automatic MEALTIMER* Clock is designed to turn the oven on and off at times you set, even when you are not around. Automatic baking is ideal for foods which do not require a preheated oven, such as meats and casseroles.
To start baking now and stop automatically: 1. Position rack(s) properly and place the food in the oven. 2. Make sure the clock is set to the right time of day. 3. Push in and turn the Stop Time Knob clockwise to the time you want the oven to shut off.
Optional Rotisserie If you would like a rotisserie for your oven, you can order a kit (Part No. RCK-79/261881) from your Whirlpool Dealer. The kit includes easy installation instructions. Optional Door Panel Pat If you would like to change the color of your oven door glass to white or almond, you can order one of these kits; White (Kit No.
Surface Units and Reflector Bowls 2. Lift the edge of the unit, opposite the receptacle, just enough to clear the element hold down clip and the reflector bowl. 3. Pull the surface unit straight away from the receptacle. 4. Lift out the reflector bowl.
3. Hold the surface unit as level as possible with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle. 2. Line up 0~ bowl with tacle and clip. lenings in the reflector the surface unit recep- the element hold dow 4.
Using the Self-Cleaning Cycle The Self-Cleaning cycle uses very high heat to burn away soil. Before you start, make sure you understand exactly how to use the Self-Cleaning cycle safely. Before You Start 1. Clean the shaded areas by hand. They do not get hot enough DO NOT clean the fiberglass seal.
Setting the Controls Be sure the k&hen Is ventilated during the SeWCleanIng cycle. This will help normal smoke and heat odors to disappear from the room as quickly as posslbl 4. Set the Oven Selector and Oven Temperature Control on CLEAN. The “on” Signal Light will come on, 3.
Special Tips l Keep the kitchen well ventilated during the Self-Cleaning cycle to help get rid of normal heat, odors and smoke. l Clean the oven before it gets heavily soiled. Cleaning a very soiled oven takes longer and results in more smoke than usual.
Cleaning Chart PART WHAT TO USE HOW TO CLEAN Exterior surtaces (stalnless steel finish) Warm soapy water and a soft cloth. Plastic scrubbing pad for stubborn spots. l Wipe off regularly when range is COOI. l Do not allow food containing acids (such as vinegar, tomato, lemon juice or milk) to remain on surface.
The Oven Light The oven light will come on when you open the oven door, To Replace: 3. Remove the light bulbfrom its socket. Replace the bulb with a 40-watt appliance bulb. 2. Remove the bulb cover in the back of the oven by pulling out and pushing the wire holder to the side.
If you need service or assistance, we suggest you follow these five steps: 1. Before calhg for if cooking results aren’t what you assistance... expected: Performance problems often result from little things you can find and fix without tools of any kind.
3. If you need service*... Whirlpool has a nationwide network of fran- chised TECH- CAREa Service TECH-CARE Companies. FRANCHISED SERVICE TECH-CARE serv- ice technicians are trained to fulfill the product war- ranty and provide after-warranty service,anywhere in the United States.
Notes 23.
WHIRLPOOL” RANGE PRODUCT WARRANTY EROOI LENGTH OF WARRANTY WHIRLPOOL WILL PAY FOR FULL ONE-YEAR WARRANTY FSP” replacement parts and repair labor to From Date of Purchase correct defects in materials or workmanship. Service must be provided by a franchised TECH-CARE 1 service company.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Whirlpool RS660BXV c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Whirlpool RS660BXV - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Whirlpool RS660BXV, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Whirlpool RS660BXV va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Whirlpool RS660BXV, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Whirlpool RS660BXV.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Whirlpool RS660BXV. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Whirlpool RS660BXV ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
