Manuel d'utilisation / d'entretien du produit UA466ZL du fabricant Uniden
Aller à la page of 20
WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page a.
Contents Precautions .............................................................................................1 Introduction .............................................................................................2 Included with your WHAM ...
1 Precautions! Before you read anything else, please observe the following: Rechargeable Nickel-Metal-Hydride Battery W arning • This equipment contains a rechargeable Nickel-Metal-Hydride battery . • The rechargeable Nickel-Metal-Hydride battery contained in this equipment may explode if disposed of in a fire.
2 Introduction WHAM is an accessory of the POLARIS ™ . The Uniden WHAM 900 MHz analog wireless mic is designed to provide you with years of trouble-free service. Its rugged components and materials are easily capable of withstanding the harsh marine environment.
3 Included with your WHAM WHAM Owner ’ s Manual (UAZZ01466ZZ) WHAM Control Unit Drop-in Charger (WH85) DC Adapter (WZ1244) AC Adapter (AD-168) Battery (BT -446) Alkaline Battery T ray Belt Clip (GBC.
4 Controls and Indicator s 1. SCAN/MEM - Select Scan mode and setup Memory channels. Press this key to activate the Scan operation. Press and hold this key for 2 seconds to place a channel into Scan Memory or remove a channel from Scan Memory . 2. POWER/VOL - This is to control the wireless mic power and speaker volume.
5 1. TX (Transmit) - Indicates transmitting. TRI (Triple W atch) - Indicates Triple W atch Mode and T riple W atch Scan Mode. 2. HI (High) - Indicates transmit output is 25 Watts. LO (Low) - Indicates transmit output is 1 W att. 3. USA - Indicates US Channel Mode.
6 Getting Started Mounting the Drop-in Charger 1. Mount the drop-in charger to either a bulk head or dash. 2. Plug one end of the AC adapter into a wall outlet, or the DC adapter into a cigarette lighter socket, and the other end into the drop-in charger .
7 Installation Installing the Battery Pack 1. Use a coin or screw driver to loosen the screw on the cover . 2. Unlock both sides of the battery compartment. 3. Open the cover . 4. Connect the battery pack (BT -446) connector observing the correct polarity (black and red wires) to the jack inside the battery compartment.
8 Installing the Beltclip 1. Place the beltclip on the mounting area on the back of the WHAM , making sure the hole in the clip lines up with the notch on the back of the WHAM . 2. Insert the screw into the corresponding hole and tighten. Or 1. Put the alkaline battery tray inside, and install the 3 AAA batteries in the tray .
9 Control Unit Connection and Installation 1. Connect the Control Unit cable and the Remote Connector . 2. Choose the best location for the POLARIS and the Control Unit. • Away from the vessels compass. • Away from metal objects that might interfere or obstruct the signal.
10 Power On/Off Press and hold POWER/VOL for 2 seconds to turn the WHAM On. Y ou can turn the WHAM Off by pressing and holding POWER/VOL for 2 seconds again. * If you are not able to turn the WHAM Off, press and hold POWER/VOL for more than 15 seconds.
11 V olume Adjusting 1. When you press POWER/VOL , the volume indicator appears on the display . 2. Press ▲ to turn the volume up, press ▼ to turn the volume down. 3. When you finish adjusting the volume, press the POWER/VOL to exit from the volume-adjusting mode.
12 Registering the WHAM to the POLARIS Note: When you use the WHAM in addition to the POLARIS wired mic, please set the BASE ID for the POLARIS the same as the WHAM . (Please refer to the Owners Manual for the POLARIS ). 1. When the WHAM is turned On for the first time, the following screen appears.
13 Hail T o access the Hail mode, press and hold MENU/HAIL for more than 2 seconds on the WHAM . The HA icon appears on the display . Press the PTT switch on the microphone, hold the microphone approximately two inches away from your mouth, and speak clearly in a normal voice.
14 Distress Note: Y ou must set the user MMSI in order to send a Distress call. Please see the POLARIS Owner ’ s Manual on page 40 to set the MMSI. This feature will allow you to transmit a Distress call. 1. In order to transmit a Distress call, press and hold DISTRESS for 5 seconds.
15 Y our WHAM is a precision piece of electronic equipment and you should treat it accordingly . Due to the rugged design, very little maintenance is required. However , a few precautions should be observed: • Y ou are responsible for continued FCC technical compliance of your radio.
16 General Standard V oltage : Portable Unit 3.6 V DC ± 0.1 V Base Unit 13.8 V DC ± 0.1 V Operating T emperature : – 10 ° C to + 50 ° C Channel : 20 (from 902.244203 MHz to 927.698745 MHz) Standard Deviation : 1 kHz ± 40 kHz Dev . Buttons : POWER, SCAN, WX, 16/9, MENU, H/L, ▲ / ▼ Size : H 1 17.
17 W arr anty W ARRANTOR: UNIDEN AMERICA CORPORA TION ( “ Uniden ” ) ELEMENTS OF W ARRANTY : Uniden warrants, for three years, to the original retail owner , this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below .
WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page b.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Uniden UA466ZL c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Uniden UA466ZL - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Uniden UA466ZL, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Uniden UA466ZL va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Uniden UA466ZL, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Uniden UA466ZL.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Uniden UA466ZL. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Uniden UA466ZL ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
