Manuel d'utilisation / d'entretien du produit PA3314U du fabricant Toshiba
Aller à la page of 48
T OSHIBA Advanced Port Replicator III User ’ s Manual.
Copyright © 2003 by TOSHIBA Corporation. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of TOSHIBA. No patent liability is assumed, with respect to the use of the informa- tion contained herein.
FCC Notice "Declaration of Conformity Information" This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion.
Cont act Address: TOSHIBA America Information Systems, Inc. 9740 Irvine Boulevard Irvine, CA 92618-1697 Telephone: (949) 583-3000 EU Declaration of Conformity TOSHIBA declares, that the product: PA331.
v T able of Content s Preface Manual contents ................................................................................. vii Conventions ....................................................................................... viii Abbreviations .
vi Chapter 4 Communications Modem ................................................................................................ 4 - 1 Connecting ......................................................................................... 4 - 1 Disconnecting .
vii Preface Congratulations on your purchase of the TOSHIBA Advanced Port Replicator III. This interface greatly increases the expandability of your computer. This manual tells how to set up and begin using your Advanced Port Replicator III and provides tips on care and troubleshooting.
viii User's Manual Conventions This manual uses the following formats to describe, identify, and highlight terms and operating procedures. Abbreviations On first appearance, and whenever necessary for clarity, abbreviations are enclosed in parentheses following their definition.
1-1 I NTRODUCTION Chapter 1 Introduction This chapter provides an equipment checklist, and it identifies the Port Replicator’s features and accessories. Equipment checklist Carefully unpack your Port Replicator. Save the box and packing materials for future use.
1-2 User’s manual I NTRODUCTION Ports Parallel Parallel printer or other parallel device (ECP compatible). Serial RS-232C compatible port (16550 UART compatible). PS/2 mouse Connects an external PS/2 mouse. PS/2 keyboard Connects an external PS/2 keyboard.
1-3 I NTRODUCTION Special features Security Security lock slot Connects an optional security lock to anchor the Port Replicator to a desk or other large object.
1-4 User’s manual I NTRODUCTION.
2-1 T HE G RAND T OUR Chapter 2 The Grand T our This chapter identifies the various components of your Port Replicator. Front Figure 2-1 shows the Port Replicator’s front and right side. Figure 2-1 The front and right side Computer This is the computer interface.
2-2 User’s manual T HE G RAND T OUR Power switch Press the power switch to turn the docked computer’s power on and off. NOTE: Pressing the power switch has no effect if a computer is not connected to the Port Replicator. Slide adjuster If necessary, slide the adjuster forward or backward so that it will be flush against the computer.
2-3 T HE G RAND T OUR Back Figure 2-2 shows the Port Replicator’s back and left side. Figure 2-2 The back and left side Line-in jack A standard 3.5 mm mini line-in jack enables connection of a stereo device for audio input. Line-out jack A standard 3.
2-4 User’s manual T HE G RAND T OUR Universal Four Universal Serial Bus ports are on the back. The Serial Bus ports comply with the USB 2.0 standard The ports also (USB 2.0) ports support USB 1.1. The number of the USB ports of DMI information may differ from the number of actual USB ports.
2-5 T HE G RAND T OUR LAN jack This jack lets you connect to a LAN. The Port Replicator has support for Ethernet LAN (10 megabits per second, 10BASE-T), Fast Ethernet LAN (100 megabits per second, 100BASE-Tx) and Gigabit Ethernet LAN(1000 megabits per second, 1000BASE-T).
2-6 User’s manual T HE G RAND T OUR.
3-1 C ONNECTIONS Chapter 3 Connections The Port Replicator is designed to ensure a secure connection by a few simple operations. CAUTION: The system supports warm docking and undocking. Do not disconnect the Port Replicator from the computer while an application is running.
3-2 User’s Manual C ONNECTIONS Figure 3-1 Slide the adjuster 2 . Remove all cables from your computer’s ports. 3 . Attach the cables to the Port Replicator’s ports. 4 . Align the computer’s connector and holes with the connector and pins on the Port Replicator.
3-3 C ONNECTIONS Connecting the AC adaptor To supply AC power to the computer, connect the AC adaptor according to the steps below. CAUTION: Only use the AC adapter supplied with this Port Replicator or included with your computer. Use of any incompatible adaptor could damage your computer.
3-4 User’s Manual C ONNECTIONS Disconnecting the Port Replicator To disconnect the Port Replicator, follow the steps below. 1 . Set the computer lock to the unlock position. 2 . Make sure you perform one of the following: • Save all your work. • Turn off the computer’s power in any mode: boot, suspend or hibernation.
3-5 C ONNECTIONS Security lock A security lock enables you to anchor the Port Replicator to a desk or another heavy object to help prevent unauthorized removal of the Port Replicator.
3-6 User’s Manual C ONNECTIONS.
4-1 C OMMUNICATIONS Chapter 4 Communications A jack enables easy connection to a local-area network without the need of a PC card or other adaptor. NOTE: When you use your computer with the Port Replicator connected to it, do not attach any cables from external devices to your computer.
4-2 User’s Manual C OMMUNICATIONS Disconnecting To disconnect the modem cable, follow the steps below. 1 . Pinch the lever on the connector in the telephone jack and pull out the connector. 2 . Disconnect the cable from the Port Replicator in the same manner.
4-3 C OMMUNICATIONS Connecting To connect the LAN cable, follow the steps below. 1 . Save all your work. Turn off the power to the computer and to all external devices connected to the Port Replicator and to the computer. 2 . Plug one end of the cable into the Port Replicator’s LAN jack.
4-4 User’s Manual C OMMUNICATIONS Universal Serial Bus (USB 2.0) port s A USB mouse, keyboard, and/or diskette connected to the Port Replicator via any connection other than a first tier hub, will not work until the OS has started. Using the USB diskette drive A 3 1/2" diskette drive connects to the Port Replicator’s USB port.
4-5 C OMMUNICATIONS Disconnecting the USB diskette drive When you have finished using the diskette drive, follow the procedures below to disconnect it: 1 .
4-6 User’s Manual C OMMUNICATIONS Connecting 1 . Make sure the connectors are properly aligned and plug the i.LINK (IEEE1394) cable into the computer. Figure 4-4 Connecting the i.LINK cable 2 . Plug the other end of the cable into the device. Note the following when you use i.
5-1 T ROUBLESHOOTING Chapter 5 T roubleshooting This chapter provides tips to correct problems, should any occur. It also describes how to contact TOSHIBA should you encounter problems that you cannot resolve. Before you call Toshiba, please read the Before you call section in this chapter.
User’s Manual 5-2 T ROUBLESHOOTING AC power If your computer is connected to the AC adaptor and you cannot turn on the computer, check your computer's DC IN 15V indicator.
5-3 T ROUBLESHOOTING Overheating power down If the computer’s internal temperature becomes too high, the computer will automati- cally enter Resume mode and shut down. Problem P rocedure Computer enters Leave the computer off until its interior reaches Resume mode and room temperature.
User’s Manual 5-4 T ROUBLESHOOTING PS/2 mouse Problem Procedure No response from Make sure the PS/2 mouse cable’s 6-pin PS/2 mouse connector is firmly connected to the PS/2 mouse port on the Port Replicator.
5-5 T ROUBLESHOOTING Printer Refer also to your computer user’s manual. Check the troubleshooting and other relevant sections in your printer and software documentation. Problem Procedure Printer does not Check that the printer is connected to an electric turn on.
User’s Manual 5-6 T ROUBLESHOOTING Monitor (analog external monitor/DVI monitor) Refer also to your computer user’s manual and to your monitor’s documentation. Problem Pr ocedure Monitor does not Make sure that the monitor’s power switch is on.
5-7 T ROUBLESHOOTING Sound system Refer also to your computer user’s manual Problem P rocedure No sound is heard Adjust the volume control dial. Check the software volume settings. Make sure the line-out connection is secure. Check Windows Device Manager.
User’s Manual 5-8 T ROUBLESHOOTING If you are using an operating system that does not support USB, you can still use a USB mouse and/or USB keyboard. If these devices do not work, make sure the USB Legacy Emulation item in HW Setup is set to Enabled .
5-9 T ROUBLESHOOTING You place a call, Make sure the settings are correct in your but a connection communications application. can’t be made After making a call, Make sure the tone or pulse selection in your you don’t hear a ring communications application is set correctly.
User’s Manual 5-10 T ROUBLESHOOTING LAN Problem P rocedure Cannot access LAN C ontact the system administrator or if the problem persists, contact your dealer. i.LINK (IEEE1394) Problem Pr ocedure i.LINK device does Make sure the cable is securely connected to not function the computer and to the device.
5-11 T ROUBLESHOOTING TOSHIBA support TOSHIBA support If you require any additional help using your computer or if you are having problems operating the Port Replicator, you may need to contact TOSHIBA for additional technical assistance. Before you call Some problems that you experience may be related to software or the operating system.
User’s Manual 5-12 T ROUBLESHOOTING Outside of Europe Australia TOSHIBA Australia Pty. Ltd. Information Systems Division 84-92 Talavera Road North Ryde N.S.W. 2113 Sydney Canada TOSHIBA of Canada Ltd. 191 McNabb Street, Markham, Ontario L3R 8H2 China TOSHIBA Computer Systems (Shang- hai) Co.
A-1 A PPENDIX A Appendix A S pecifications This appendix summarizes the Port Replicator’s technical specifications. Physical Dimensions Weight 1023 grams Size 356 (w) x 54 (h) x 160 (d) millimeters .
A-2 User’s Manual A PPENDIX A.
B-1 A PPENDIX B Appendix B AC Power Cord and Connectors The power cord’s AC input plug must be compatible with the various international AC power outlets and the cord must meet the standards for the country/region in which it is used. All cords must meet the following specifications: Length: Minimum 2 meters Wire size: Minimum 0.
B-2 User's Manual A PPENDIX B The following illustrations show the plug shapes for the U.S.A. and Canada, the United Kingdom, Australia and Europe.
Index-1 I NDEX Index A AC adaptor specifications 1-1, 2-5 connecting 3-3 connectors location 2-3 C CAT3 CAT5 CAT5E cables 4 - 2 Center mark 2-2 location 2-1 Computer connection port location 2-1 Compu.
Index-2 User's Manual I NDEX Monitor external 2-4 port location 2-3 problems, see Troubleshooting Mouse PS/2 mouse port location 2-3 PS/2 mouse problems, see Troubleshooting serial mouse problems.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Toshiba PA3314U c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Toshiba PA3314U - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Toshiba PA3314U, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Toshiba PA3314U va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Toshiba PA3314U, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Toshiba PA3314U.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Toshiba PA3314U. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Toshiba PA3314U ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
