Manuel d'utilisation / d'entretien du produit SRA-200E du fabricant Roland
Aller à la page of 18
Main Features • Lightweight, Compact, and Energy-Efficient Employing the latest developments in high-efficiency amplifier technology, the SRA-200E packs a powerful 100 watts per channel (at 8 ohms); yet it weighs a mere 5.
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
• Before using this unit, make sure to read the instructions below, and the Owner's Manual. ......................................................................................................... • Do not open or perform any internal modifications on the unit.
Impor tant Notes In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2 and 3, please read and observe the following: Power Supply • Do not use this unit on the same power circuit with any device that will generate line noise (such as an electric motor or variable lighting system).
Names and Functions Front Panel 1. Attenuator This adjusts the level of what is output to the speakers. Adjust for the most suitable volume according to the input level of the connected device. *W hen set to BTL mode, volume is adjusted with the Channel A attenuator.
Rear Panel INPUT 1. INPUT Connector (XLR-3-31 Type) * The pin assignment for the XLR type connectors is as shown below. Before making any connections, make sure that this pin assignment is compatible with that of all your other devices.
4. INPUT LEVEL Switch This switches the input sensitivity (+4 dBm/-10 dBm). Select the setting appropriate for use with your system. 5. MODE Switch Switches the unit between the STEREO and BTL modes. Select the mode that is appropriate for your configuration ( → p.
Connecting Other Devices Stereo Connection Channel A and Channel B may operate independently. In this mode, the SRA-200E functions as a stereo power amp, with 100 watts per channel (at 8 ohms). ● MODE switch: Set the MODE switch on the rear panel to "STEREO.
Parallel Connection Contacts for each of the SRA-200E's three types of input connectors (XLR-3-31, TRS standard phone, and screw type) are wired in parallel internally, so signals can be output unchanged and then input again at a separate device's connector, allowing connection of a multiple number of power amps.
Precautions When Connecting and T urning on the Power ● To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. ● Do not connect anything other than speakers to these terminals.
Tips about Connection ● Connections can be made using banana plugs and large-diameter cables. However, be sure only to connect cables specifically made for use with speakers.
About the Pr otection Circuits The SRA-200E features special circuitry to protect the amp and any connected devices. Whenever this is activated, the PROTECTION indicator lights, and sound is cut off from the speakers. Stop operation of the equipment, and immediately check to find the cause of the problem.
About Rack Mounting (Notes on Heat Dissipation) The SRA-200E uses a combined simple air- cooled/forced-air cooling system. When the forced-air cooling fan is activated, cooler air from outside the amp.
Tr oubleshooting There is no sound ● Check to make sure the attenuators are not rotated too far counterclockwise. ● Check to make sure the speaker cables are not shorted and that the speaker impedance is not less than 4 ohms.
Main Specifications • Rated Power Output 100 W x 2 (stereo, 8 ohms load, 1 kHz, 0.1 % or less THD) 150 W x 2 (stereo, 4 ohms load, 1 kHz, 0.1 % or less THD) 300 W (BTL, 8 ohms load, 1 kHz, 0.
16 Dimensions 16"-15/16 19" 13"-1/16 1"-15/16 1"-3/4 5/16 1 1"-5/8 1/4.
Index Air Vent ............................................................................................................................................................7,13 Attaching the Rubber Feet .................................................
Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. As of June 1, 2002 (Roland) ARGENTINA Instrumentos Musicales S.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Roland SRA-200E c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Roland SRA-200E - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Roland SRA-200E, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Roland SRA-200E va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Roland SRA-200E, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Roland SRA-200E.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Roland SRA-200E. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Roland SRA-200E ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.